I, (Name) (Title) of (Exporter) HEREBY CERTIFY that to the best of my knowledge and belief the (Quantity) (cubic meters or board feed scribner) of unprocessed western red cedar timber that (Exporter) proposes to export was not harvested from State or Federal lands under contracts entered into after October 1, 1979. Signature Date (a) License requirement. As indicated by the letters “SS” in the “Reason for Control” paragraph in the “License Requirements” section of ECCN 1C988 on the CCL (supplement no.

(a) License requirement. As indicated by the letters “SS” in the “Reason for Control” paragraph in the “License Requirements” section of ECCNs 1C980, 1C982, 1C983, and 1C984 on the CCL (supplement no. 1 to part 774 of the EAR), a license is required to all destinations, including Australia, Canada, and the United Kingdom, for the export of petroleum products, excluding crude oil, listed in supplement no.

(a) Scope. In this part, references to the Export Administration Regulations (EAR) are references to 15 CFR chapter VII, subchapter C. This part implements the provisions of section 7, “Short Supply Controls,” of the Export Administration Act (EAA) and similar provisions in other laws that are not based on national security and foreign policy grounds. (b) Contents.

Under some circumstances, you may use a license issued for the export of items from the United States to export more than the value shown on that license. This additional amount is called a shipping tolerance. This section tells you, as the licensee, when you may take advantage of a shipping tolerance and the amount of shipping tolerance you are permitted to use. (a) If you have already shipped the full quantity of items approved on your license, you may not use this shipping tolerance provision.

(a) Authorization. As the licensee, you may not transfer a license issued for the export of items from the United States to any other party, except with the prior written approval of BIS. BIS may authorize a transfer of a license for export to a transferee who is subject to the jurisdiction of the United States, is a principal party in interest, and will assume all powers and responsibilities under the license for the control of the shipment of the items out of the United States.

(a) Lost, stolen or destroyed. For licensees whom BIS authorized the submission of paper applications, if a license is lost, stolen or destroyed, you, as the licensee, may obtain a duplicate of the license by submitting a letter to the BIS at the address listed in § 748.1(d)(2) of the EAR, Attention: Duplicate License Request.” You must certify in your letter: (1) That the original license ([number] issued to [name and address of licensee]) has been lost, stolen or destroyed; and (2) The circumstances under which it was lost, stolen or destroyed. (b) Hong Kong Trade Department.

(a) Revocation. All licenses for exports or reexports are subject to revision, suspension, or revocation, in whole or in part, without notice. BIS's Office of Exporter Services may revoke any license in which a person who has been convicted of one of the statutes specified in section 11(h) of the EAA, at the discretion of the Secretary of Commerce, has an interest in the license at the time of the conviction. It may be necessary for BIS to stop a shipment or an export or reexport transaction at any stage in the process (e.g., in order to prevent an unauthorized export or reexport).

(a) Scope. (1) Unless limited by a condition set out in a license, the export, reexport, or transfer (in-country) authorized by a license is for the item(s), end-use(s), and parties described in the license application and any letters of explanation.

(a) Intent to deny notification. If BIS intends to deny your license application, BIS will notify you in writing within 5 days of the decision.

(a) Overview. (1) All license applications will be resolved or referred to the President no later than 90 calendar days from the date of BIS's registration of the license application. Processing times for the purposes of this section are defined in calendar days. The procedures and time limits described in this part apply to all license applications registered on or after February 4, 1996.